English
  • 中文简体
  • English
  • 日本語
  • 한국어
Home> Products>Flat Roof PV Mounting Systems>Low Ballasted Aluminum PV Mounting System>STTS SGrid - Low Ballasted Aluminum PV Mounting System

STTS SGrid - Low Ballasted Aluminum PV Mounting System

STTS SGrid can be used to optimize the roof load, and increase installed capacity on roof. The matrix structure distributes the necessary total ballast on roof, and thus obviously reduces the dimensions of single ballast. Meanwhile, the wind deflector also reduces the wind damage to the system and greatly decreases the required load bearing of the roof. For any inquiry, please email : dennis@serve-energy.com

Keywords: Chinese Manufacturer Of Low Ballasted Aluminum PV Mounting System Wholesale Low Ballasted Aluminum PV Mounting System From China Low Ballasted Aluminum PV Mounting System Made In China Low Ballasted Aluminum PV Mounting System Procurement

STTS  SGrid--Low Ballasted Aluminum PV Mounting System


STTS  SGrid can be used to optimize the roof load, and increase installed capacity on roof. The matrix structure distributes the necessary total ballast on roof, and thus obviously reduces the dimensions of single ballast. Meanwhile, the wind deflector also reduces the wind damage to the system and greatly decreases the required load bearing of the roof.


Advantages


1. Gridding design:

(1)The whole system is closely connected, to effectively reduce the necessary ballast;

(2)The reproducible modular design greatly lower the installation difficulty and improve the installation convenience;

(3)The compact arrangement of solar modules increases the installed capacity.


2. Maximum pre-assembly:

(1)The bottom beam, girder, and support are folded into an assembly to improve the installation efficiency.


3. Optional design:

(1)An optional rear support is available (SGrid Adjustable), to realized easy adjustment of inclination angle in a range of ±8o;

(2)Some components can be replaced by hot galvanized steel to reduce the cost.


4. Stable structure:

(1)The system is made of high strength aluminum alloy 6005-T5;

(2)The structural strength will be calculated to ensure safety and stability;

(3)The surface is anodized to prevent corrosion and resist the weather for more than 25 years.


Technical Data:


Installation site:Flat RoofsFoundation:Concrete
Inclination angle: 0-50°Design wind load:1.0KN/m2
Design snow depth:60cmModule type:Framed and Frameless
Orientation of solar module: Landscape
Design Standards:GB50009-2012;DIN1055;JIS C8955:2017;AS/NZS1170;BS6399; ASCE7-10

Structural member:AL6005-T5 (anodized coating ≥ 10 microns averagely) 

Q235B Galvanized Steel (galvanized coating ≥70 microns averagely)


Fastener:Stainless steel SUS304Warranty:15 years

Chinese Manufacturer Of Low Ballasted Aluminum PV Mounting System

Chinese Manufacturer Of Low Ballasted Aluminum PV Mounting System

Chinese Manufacturer Of Low Ballasted Aluminum PV Mounting System

        tag: Chinese Manufacturer Of Low Ballasted Aluminum PV Mounting System, Wholesale Low Ballasted Aluminum PV Mounting System From China, Low Ballasted Aluminum PV Mounting System Made In China, Low Ballasted Aluminum PV Mounting System Procurement, Low Ballasted Aluminum PV Mounting System, Low Ballasted Aluminum PV Mounting System From China

Message BoardPlease write down your question and we will respond to you within 24 hours.